Product Description
100m to 1000m Crawler Wheels Truck-mounted Pneumatic Water well Drill Rig bore well drilling machine
The water well drilling rig is a lightweight, efficient and multifunctional drilling equipment powered by a diesel engine. It is mainly suitable for drilling water wells, agricultural irrigation wells and other wells, especially for water extraction in mountainous areas and rock formations. project. This series of drilling rigs adopt new hydraulic technology and are equipped with high-torque hydraulic motor rotation and large-bore hydraulic cylinder propulsion.
Product name
|
100m to 1000m Pneumatic Water well Drill Rig bore well drilling machine
|
Drilling depth
|
100m 200m 150m 300m 400m 500m 600m 800m 1000m
|
Drilling hole diameter
|
140-500mm
|
Type
|
Crawler Wheels Truck-mounted
|
Drilling procedure:
1. Move the drilling rig to the location where the operation is required, and operate the telescopic cylinder handle and the outrigger cylinder handle to adjust the drilling rig parallel to the ground.
2. Operate the handle of the tilt cylinder to tilt the carriage to the stop position, tighten the two fixing bolts with a wrench, and insert the fixing pin.
3. Install the first drill pipe (2 meters), impactor, and drill bit, and fix the impactor with the impactor positioning sleeve.
4. Finely adjust the machine by operating the handle of the outrigger cylinder to ensure that the drill pipe is vertically downward.
5. Open the inlet ball valve;
6. Adjust the needle valve of the oil injector until oil droplets are seen at the bit;
7. Slowly move the rotor downward to make the impactor bit contact the ground surface, and at the same time push the impact ball valve handle to the appropriate angle to drill;
8. After the rock hole is formed, the impactor stabilizing sleeve should be replaced with a drill pipe stabilizing sleeve, and then the impact ball valve handle should be pushed to the extreme position for formal rock drilling.